Seat Car Warranty Terms & Conditions
Gold Cover (highest level of cover)
Maximum claim is the value of the car. Mileage limit is 100,000 miles.
Covered:
Everything is covered except:
Wear and Tear: Bodywork of any kind, sheet metal, body panels, bodywork or glass sealants or bondings, paintwork, paint, lamp units, glass and mirrors (except in the case where they suffer an electrical or mechanical failure), springs (other than road springs) upholstery, carpets, trim, all weather strips and seals, channels and guides, locks, hinges, handles, check straps and cosmetic items.
Casings: (unless damaged by the failure of a covered component).
Normal service replacement items: Auxiliary belts, Batteries, Bonnet, boot and fuel flap release cables, Brake friction material and discs/drums, Clutch facings, Core plugs, Diesel glow plugs, Diesel particulate filters (DPF), Distributor caps, Electrical connection blocks, terminals and 
fuses, Engine, gearbox, axle and drive line mountings.
Exhaust systems (although catalytic converters are covered for internal failure only), Fuel filters, Handbrake cables, Hoses, hose clips and connectors, HT leads, Light bulbs, Oil filters and gaskets, PAS high pressure hose/pipes, Pollen/odour filters, Reprogramming/software updates, unless required as part of a replacement part repair, Rotor arms, Spark plugs, Sunroof cables, convertible roof material and straps Tyres, Wheels, Wiper blades.
Silver (second highest level of cover)
Maximum claim is the value of the car. Mileage limit is 100,000 miles.
Covered:
Engine: All internal parts, timing belt and tensioner, turbocharger, supercharger, all solid-state sensors and control units (including immobiliser ECU) of the engine management system including supply relays, ignition switch, petrol or diesel injection and lift pumps, fuel injectors and pipes, starter motor, starter motor relay, alternator, water pump, thermostat, engine mountings, excluding worn parts.
Gearbox: (automatic or manual):All internal parts, gear selection linkages and ECUs, automatic selection switchgear, reverse light switch, excluding worn parts.
Clutch: Clutch cover, centre plate, release bearing, cable and adjuster, pedal, solenoid, switch, excluding worn parts and frictional material.
Suspension: All parts including self-levelling system, wheel bearings, switch gear, ECU and relay, hydraulic pumps and valves, excluding worn parts.
Steering system: All parts included from the steering wheel to the track rod ends, rear wheel steering (if fitted), PAS system (excludes drive belt), solid- state sensors and relays, excluding worn parts.
Braking system: All parts including ABS system components, stop light switch, relays, discs, drums, cylinders, pipes and hoses, excluding worn parts and frictional material.
Drive-line components: All parts including four wheel drive system, propeller or drive shafts including gaiters and centre bearing, differential and transfer box internal components, switchgear, ECU and relay, excluding worn parts and frictional material.
Casings: Casings are covered only when damaged by the failure of an insured component.
Sundries: Working materials i.e. oils, filters, antifreeze are claimable as a direct result of a valid claim providing the vehicle is not within 1,000 miles of its next scheduled service. The rectification of oil leaks is not covered and the cost of seals and gaskets will only be accepted where they are required as a direct consequence of a valid claim under the insurance.
Not covered: Any item not listed is not covered.
Bronze: (Basic cover)
Any car qualifies. Maximum Claim is £1000. Total number of claims cannot exceed £5000.
Covered:
Engine: All internally lubricated components, including but not limited to the following: Cylinder head, cylinder head gasket, valves (excluding decarbonisation, burnt or pitted valves and valve seats), valve springs, valve guides, camshaft and bearings, camshaft followers, hydraulic lifters, timing gears, timing chains, piston and piston rings, cylinder liners and liner seals, cylinder block, connecting rods and small end bearings, gudgeon pins, crankshaft and crankshaft bearings, oil pump and oil pump drive, distributor driveshaft, flywheel, starter motor ring gear, engine management sensors.
Timing belts: Timing belts and tensioners are covered providing that the last due change has taken place as specified by the manufacturer's schedule (proof required). Damage subsequently caused if timing belt has not been changed as specified by the manufacturer is specifically excluded.
Turbocharger/ Supercharger: Factory fitted turbocharger or supercharger, intercooler and wastegate.
Gearbox: All internally lubricated components, including but not limited to the following: Gears, shafts, synchroniser hubs and baulk rings, selector shafts and selector forks, internal bearings and bushes, oil pump, valve and valve block, clutches and brake bands, governor, torque converter, modulator valve, gearbox sensors. (Excluding external linkages).
Final drive: All internally lubricated components, including but not limited to the following: Crown wheel and pinion, differential gears and bearings, 4X4 transfer box, halfshaft, halfshaft bearings, driveshafts, bearings and constant velocity joints, propeller shaft universal joints and centre bearing, wheel bearings, final drive sensors. (Excluding rubber boots and gaiters).
Casings: Casings are covered only when damaged by the failure of an insured component.
Sundries: Working materials i.e. oils, filters, antifreeze are claimable as a direct result of a valid claim providing the vehicle is not within 1,000 miles of its next scheduled service.
Miscellaneous: The rectification of oil leaks is not covered and the cost of seals and gaskets will only be accepted where they are required as a direct consequence of a valid claim under the insurance.
Not covered:
Any components specifically not listed are not covered.
Important Notice about this [name] Extended Warranty Review
The above information has been gained from the manufacturer's sales literature and press office, and is correct as of May 2012. Please contact us with any omissions or amendments.